ADC AD-25 Installation Manual download pdf (Page 16)

SECTION III

INSTALLATION PROCEDURES

Installation should be performed by competent technicians in accordance with local and state codes. In the

absence of these codes, the installation must conform to applicable American National Standards: ANSI Z223.1-

LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA NO. 70-LATEST EDITION (National Electrical

Code) or in Canada, the installation must conform to applicable Canadian Standards: CAN/CGA-B149.1-M91

(Natural Gas) or CAN/CGA-B149.2-M91 (Liquid Propane [L.P.] Gas) or LATEST EDITION (for General

Installation and Gas Plumbing) or Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION

(for Electrical Connections).

A. UNPACKING/SETTING UP

Remove protective shipping material (i.e., plastic wrap and optional shipping box) from dryer.

IMPORTANT: Dryer must be transported and handled in an upright position at ALL times.

NOTE: For OPL (non-coin) dryer models equipped with locks (top control door has no lock, secure

in place with screws), the lock used is a dummy lock and no key is supplied or needed. The

lock can be turned with any key, a screwdriver, a small coin, or any small sharp object. For

coin-operated dryers, the MK-100 (master key for both the control door and lint door)

should be made accessible because it will be needed throughout various phases in the

installation of the dryer.

The dryer can be moved to its final location while still attached to the skid or with the skid removed. To unskid

the dryer, locate and remove the four (4) bolts securing the base of the dryer to the wooden skid. Two (2) are

at the rear base (remove the back panel for access), and two (2) are located in the bottom of the lint chamber.

To remove the two (2) bolts located in the lint chamber area, remove the lint door.

With the skid removed, to make it easier to slide the dryer into its final position, slightly lower ALL four (4)

leveling legs, so that the dryer will slide on the legs instead of the base frame.

To increase bearing life and improve efficiency, the dryer should be tilted slightly to the rear.

The lint coop is supported during shipping by a bracket. REMOVE THIS BRACKET BEFORE STARTING

THE DRYER.

1. Leveling Dryer

The dryer is equipped with four (4) leveling legs, one (1) at each corner of the base. Two (2) are located

at the rear of the dryer base, and two (2) are located in the lint chamber (coop). To increase bearing life

and improve efficiency, the dryer should be tilted slightly to the rear.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 60 61

No comments

ADC AD-25 Installation Manual Page 16