ADC Network Unit User Manual download pdf (Page 21)

August 7, 2006 Chapter 3: Provisioning

AIWN-UM-7001-01 3-3

Configuration

Get Configuration

Purpose:

Show the current configured parameters.

Command:[all privileges]

GET CONFIGURATION

Interface Speed and Negotiation

Purpose:

Configure speed and negotiation mechanism for the NETWORK and SUBSCRIBER interfaces.

Command:[RW, SECURE privilege]

SET [NETWORK|SUBSCRIBER] INTERFACE SPEED 10|100|1000 [AUTO|FORCE]

Example 1: SET INTERFACE SPEED 100

Example 2: SET NETWORK INTERFACE SPEED 1000 FORCE

Status Commands: [all privileges]

GET CONFIGURATION

Configure Data Rate

Purpose:

Configure transmit and receive data rates relative to the SUBSCRIBER interface and independent of the link speed.

This mechanism provides a mechanism to limit the amount of bandwidth that the SUBSCRIBER can use.

Command:[RW, SECURE privilege]

SET [TRANSMIT|RECEIVE] DATA RATE FULL|<value>

TRANSMIT or RECEIVE is optional and is specified to identify a specific direction. If not specified, both directions

will be targeted. The data rate is specified in megabits by supplying a <value> number from 1 to 1000, or FULL to

allow the full rate of the interface.

Example: SET DATA RATE FULL

Example: SET TRANSMIT DATA RATE 15

Status Commands: [all privileges]

GET CONFIGURATION

Note: NETWORK or SUBSCRIBER is optional and is specified to identify a specific interface. If not

specified, both interfaces will be targeted. AUTO or FORCE is optional and indicates whether the

interface(s) should auto-negotiate up to the configured speed or if the interface should be forced to the

indicated speed. Negotiation defaults to AUTO if not specified.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

No comments

ADC Network Unit User Manual Page 21