ADC Network Unit User Manual download pdf (Page 24)

Chapter 3: Provisioning August 7, 2006

3-6 AIWN-UM-7001-01

Configure OAM for EXFO Operation

Purpose:

Configure OAM to interoperate with EXFO test equipment in a VLAN environment. Note: In addition to configuring

OAM extensions, this command also changes the MAC address from which OAM messages will be accepted from

the slow protocols address to an ADC unique multicast address of 01:80:51:00:00:00.

Command:[RW, SECURE privilege]

SET EXFO OAM CONFIGURATION

Status Commands: [all privileges]

GET CONFIGURATION

Configure OAM Mode of Operation

Purpose:

Configures OAM to operate in ACTIVE or PASSIVE mode or to turn OAM processing off.

Command:[RW, SECURE privilege]

SET OAM MODE ACTIVE|PASSIVE|OFF

Status Commands: [all privileges]

GET OAM STATUS

Configure OAM Extensions

Purpose:

Configure the individual OAM extensions that allow for OAM operation over a VLAN and for use with EXFO test

equipment.

Command:[RW, SECURE privilege]

SET DISCOVERY MODE ON|OFF

Turns on abbreviated discovery mode for use with EXFO test equipment.

SET SWAP ADDRESS MODE ON|OFF

When on, forces ENIU to swap the source and destination addresses and recalculate the frame check sequence

during loopback operations so that test frames can be returned directly to the sender.

SET UNICAST MODE ON|OFF

When on, forces the ENIU to send OAM messages to the unicast address of the active mode OAM peer that is

found during OAM discovery instead of sending messages to the slow protocols address.

SET VLAN MODE ON|OFF

When on, allows the ENIU to discover VLAN tagged OAM protocol messages during OAM discovery and then use

that tag to continue OAM protocol communications.

Status Commands: [all privileges]

GET CONFIGURATION

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

ADC Network Unit User Manual Page 24