ADC AD-200 Service Manual download pdf (Page 82)

WARNING: TO ENSURE THAT THE DRIVE IS NOT UNEXPECTEDLY STARTED, TURN

OFF AND LOCKOUT AND/OR TAG POWER SOURCE BEFORE

PROCEEDING. FAILURE TO OBSERVE THESE PRECAUTIONS COULD

RESULT IN PERSONAL INJURY.

WARNING: Drive shaft assembly is heavy. IMPROPER HANDLING CAN CAUSE

PERSONAL INJURY.

2. Drive Motor Component(s)

a. Drive Motor Replacement

1) Discontinue electrical power to the

dryer.

2) Mark and identify the wires that will

be removed for proper reinstallation.

3) Loosen the turnbuckle and remove

V-belts.

4) Mark the inside of the shaft before

removing the taper lock bushing (for

proper reinstallation).

5) Remove the taper lock bushing and motor pulley.

Refer to Taper Lock Bushing and Drive Motor Pulley Replacement (Step #3 thru Step #6)

on page 79.

6) Remove the bolts securing the motor to the motor mount.

7) Install new motor and secure to motor mount.

8) Reinstall motor pulley and taper lock bushing.

Refer to Taper Lock Bushing and Drive Motor Pulley Replacement (Step #7 thru Step #11)

on page 79.

9) Reinstall V-belts then tighten turnbuckle.

IMPORTANT: DO NOT OVERTIGHTEN TURNBUCKLE.

10) Rewire the new drive motor in the same order as the wiring from the motor that was removed.

a) Diagram is usually affixed to the side of the motor.

11) Reestablish electrical power to the dryer.

b. V-Belt Replacement

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 105 106

No comments

ADC AD-200 Service Manual Page 82