ADC Network Unit User Manual download pdf (Page 29)

AIWN-UM-7001-01 A-1

Appendix

SPECIFICATIONS

Specifications for the ENIU are listed in Table A-1.

Table A-1. Ethernet NIU Specifications

PARAMETER SPECIFICATION Remarks

Power

Voltage –48VDC, or 110 to 240VAC (50–60 Hz)

Operating Voltage +5 VDC Backplane connector

Input Current 0.25 A maximum Normal operation

Fuse Size 1.0 Amps –48 VDC

Environmental

Operating Conditions

+23

°F to +122°F (–5°C to +50°C) 5% to 90% RH

Storage Conditions

-40

°F to +185°F (-40°C to +85°C) 10% to 95% RH

No Condensation

Mechanical

Dimensions D x W x H

1.55 in.

× 4.25 in. × 9.09 in.

(3.94 cm

× 10.8 cm × 23.1 cm)

Weight 1.8 lb. (0.81 kg.)

Electrical

Network Interface RJ-45, SFP

Network Data Rates Configurable to 10Mbps, 100Mbps or 1000Mbps

Customer Interface RJ-45, SFP [Small Form-factor Pluggable (SFP)

Transceiver Multi-Source Agreement (MSA)]

Customer Data Rates Configurable to 10Mbps, 100Mbps or 1000Mbps

Copper Media

Requirements

10Mbps UTP Category 3, 4, 5 or better Two twisted pair

100Mbps UTP Category 5 or better Two twisted pair

1000Mbps UTP Category 5e or better Four twisted pair

Distance 328 feet (100 meters) Copper

Optical Media Requirements 850 to 1550 nm Single Mode or Multi-Mode

fiber

Distance The maximum distance that any optical link can

support is dependent upon attenuation and dispersion

at a particular wavelength, maximum bit rate, receiver

sensitivity, splice and connector loss, etc. Refer to SFP

specifications for operating parameters.

Optical

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

ADC Network Unit User Manual Page 29

Comments to this Manuals