ADC MM701G User Manual download pdf (Page 10)

Determine What You Need

2 MM701G and MM702G User Manual

STEP 2—DETERMINE WHAT YOU NEED

In addition to what is shipped with the modem, you need the following hardware and software

to complete the installation and configuration.

STEP 3—ATTACH FEET TO THE MODEM

Attach oval rubber feet to the modem to prevent it from slipping on surfaces (a desktop, for

example) and from scratching those surfaces. Do the following:

1 Remove the paper from the adhesive back of the oval rubber feet.

2 Attach each of the four oval rubber adhesive-backed feet to a footprint recess on the bottom

of the modem.

Equipment: Requirement:

PC Hardware:

• Ethernet NIC Card (10 Mbps) installed in each PC and other network equipment

that will be connected to the LAN. Verify if the NIC in the device which directly

connects to the modem LAN port is half- or full-duplex. The modem LAN port

must be set to the same transmission direction(s) as the NIC.

• Optional—serial interface card installed in PC (used for access to the modem

console port).

Software:

• TCP/IP protocol stack installed (see the operating system documentation for

information).

• Terminal emulation program (such as HyperTerminal) installed for access to

the command line interface. through the console port (see the operating system

documentation for information).

• Web browser installed such as Internet Explorer

Version 4.0 (or higher).

• Operating System CD-ROM (Win98, Win98SE, Win2000, WinME, or WinXP).

Ethernet hub, switch,

or router

Optional—use either a hub, switch, or a router to connect multiple PCs or other

LAN equipment to the modem Ethernet 10Base-T port (LAN port).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 167 168

No comments

ADC MM701G User Manual Page 10