ADC MM701G User Manual download pdf (Page 34)

Configuring the LAN

28 MM701G User Manual

2 Configure the following parameters:

Parameter Description

LAN Protocol Select the message format to be used for your LAN.

• Select Bridge if the LAN forwards packets based on MAC addresses. If you

selected RFC 1483 Bridge protocol for the WAN sessions (page 23), select Bridge

for the LAN traffic.

• Select Router if the LAN routes packets based on IP addresses. If you selected

RFC 1483 Router or PPP protocol for the WAN sessions (page 23), select Router

for the LAN traffic.

IP Address See your LAN administrator for LAN IP addresses.

However, if you want to change the IP address through the Web interface, enter an

IP address for the LAN (10Base-T) port provided by the LAN administrator. Or, you

can use the default IP address for the LAN port which is 10.0.0.1. If you choose to

use the default IP address, ensure that the devices on your LAN are on the same

subnet as the MM701G LAN port.

If you select Client for the DHCP configuration (below in this table), a DHCP server

on your LAN automatically provides the IP address.

Subnet Mask Enter the subnet mask for the LAN (10Base-T) port provided by the LAN

administrator. Or, you can use the default subnet mask for the LAN port which is

255.255.255.0. If you choose to use the default subnet mask, ensure that it allows

devices on your LAN to access the MM701G LAN port.

Default Gateway Enter the default IP address for a default gateway that is supplied by the service

provider.

DHCP See your LAN administrator for the DHCP selection. You selected whether or not you

wanted to enable DHCP in “Determining IP Addresses” on page 14.

However, if you want to change that DHCP selection through the Web interface,

select one of the following:

• None—DHCP is not enabled.

• Client—The MM701G is a DHCP client and can be served an IP address for the

LAN port by a DHCP server on your LAN.

• Server—The MM701G is a DHCP server and can serve IP addresses to devices

on your LAN. See DHCP Range Low and High for the ranges of IP addresses that

the MM701G can serve.

DHCP Range Low Enter the IP address supplied by your LAN administrator. This is the lowest IP

address value that the MM701G can serve when configured as a DHCP server.

DHCP Range High Enter the IP address supplied by your LAN administrator. This is the highest IP

address value that the MM701G can serve when configured as a DHCP server.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 107 108

No comments

ADC MM701G User Manual Page 34